城市安全供水综合指数研究-以太原为例

采集太原市不同区住户的自来水和12种瓶装水,分析了水中无机离子和挥发性有机物( VOCs)成分.结果表明,无机离子和VOCs的总浓度范围分别为1.08~354.18 mg/L和0.43~13.98 μg/L;自来水中的无机离子与VOCs 含量最高,约是瓶装水中浓度的三倍.加热与过滤处理措施均可改善自来水水质,对水中无机离子和VOCs的去除效果均可达19%~100%,其中过滤可能会引发VOCs的二次污染 .根据饮用水标准,使用饮用水水质指数( DWQI)模型对水质评价结果显示,太原市饮用水水质总体较好.     

近红外长余辉纳米颗粒经小鼠眼部暴露后体内分布和代谢情况

为了研究纳米颗粒通过眼部暴露后进入体内的路径及在体内的分布和代谢情况,实验采用近红外长余辉纳米探针作为示踪剂,对小鼠进行眼部暴露,随后利用活体成像技术观察其进入小鼠体内的过程及分布情况,于暴露第4天收集代谢产物,第7天取重要脏器和血液,并检测纳米探针的存在情况.结果显示纳米探针可由眼经口腔进入胃肠道中,并且纳米颗粒暴露4天后在小鼠的粪便中检测到强荧光信号,而尿液中的荧光信号较弱,暴露7 d后在小鼠的眼睑结膜、胃及眼球中检测到强荧光信号,而其余器官的荧光信号较弱.这表明通过眼部暴露后,纳米颗粒主要分布在眼和消化系统中,最后大部分经消化系统代谢.     

固定化多酚氧化酶对水中苯酚和氯酚的去除

以壳聚糖/蒙脱土插层复合物为载体,吸附法制备固定化多酚氧化酶,并以此催化氧化去除水中的苯酚、4-氯苯酚和2,4-二氯苯酚.考察了固定化多酚氧化酶的制备条件,对酚类化合物的催化氧化条件、动力学特性以及固定化酶的重复使用性能.结果表明,固定化多酚氧化酶的最佳制备条件为p H 5.0,酶与载体质量比20 mg·g-1,固定化6 h,所得固定化酶的载酶量为12.12 mg·g-1,每克单位载体酶活为12.76×103U·g-1.固定化多酚氧化酶对酚类化合物的最佳去除条件为:苯酚溶液p H 7.0,温度30℃;4-氯苯酚溶液p H 5.0,温度20℃;2,4-二氯苯酚溶液p H 5.0,温度30℃.在最佳反应条件下,酶与底物质量比为20 mg·mg-1时,固定化多酚氧化酶对苯酚、4-氯苯酚和2,4-二氯苯酚溶液去除率分别为63.6%、85.8%和87.8%.苯酚、4-氯苯酚和2,4-二氯苯酚的米氏常数Km值依次减小,最大反应速率Vmax依次增大,表明固定化酶对2,4-二氯苯酚的亲和力最强,催化速度最快.固定化酶循环使用6次(24 h)后对苯酚、4-氯苯酚和2,4-二氯苯酚的去除率分别为15.7%、24.2%和27.8%.     

芳香族化合物在XAD-4上吸附机理的研究

通过批量吸附实验考查了7种芳香族化合物在XAD-4上的吸附热力学行为.结果表明,在实验条件下,Freundlich方程能很好地拟合这7种化合物在XAD-4上的等温吸附数据,且都为优惠吸附,吸附能力均随着温度的升高而降低.结合7种化合物的分子结构描述符和Freundlich方程的吸附平衡常数,建立了QSPR模型,较高的可决系数R2(0.991)、去一法交互检验可决系数R2CV(0.985)和外部预测集交互检验系数Q2ext(0.994)表明,该模型具有较高的稳定性能和预测能力.模型结果表明,水杨酸等7种芳香族化合物在XAD-4上的Freundlich吸附平衡常数与溶质疏水性能呈正比关系,与温度、溶质分子极性和溶质分子的氢键酸度常数呈反比关系.     

Investigation of carbonyl compound sources at a rural site in the Yangtze River Delta region of China

Carbonyl compounds are important intermediates in atmospheric photochemistry, but their primary sources are still not understood well. In this work, carbonyls, hydrocarbons, and alkyl nitrates were continuously measured during November 2011 at a rural site in the Yangtze River Delta region of China. Mixing ratios of carbonyls and hydrocarbons showed large fluctuations during the entire measurement. The average level for total measured volatile organic compounds during the pollution episode from 25th to 27th November, 2011 was 91.6 ppb, about 7 times the value for the clean period of 7th-8th, November, 2011. To preliminarily identify toluene sources at this site, the emission ratio of toluene to benzene (T/B) during the pollution episode was determined based on photochemical ages derived from the relationship of alkyl nitrates to their parent alkanes. The calculated T/B was 5.8 ppb/ppb, significantly higher than the values of 0.2-1.7 ppb/ppb for vehicular exhaust and other combustion sources, indicating the dominant influence of industrial emissions on ambient toluene. The contributions of industrial sources to ambient carbonyls were then calculated using a multiple linear regression fit model that used toluene and alkyl nitrates as respective tracers for industrial emission and secondary production. During the pollution episode, 18.5%, 69.0%, and 52.9% of measured formaldehyde, acetaldehyde, and acetone were considered to be attributable to industrial emissions. The emission ratios relative to toluene for formaldehyde, acetaldehyde, and acetone were determined to be 0.10, 0.20 and 0.40 ppb/ppb, respectively. More research on industrial carbonyl emission characteristics is needed to understand carbonyl sources better.     

Enhanced catalytic complete oxidation of 1,2-dichloroethane over mesoporous transition metal-doped γ-Al2O3

High-surface-area mesoprous powders of γ-Al₂O₃ doped with Cu^2 +, Cr^3 +, and V^3 + ions were prepared via a modified sol–gel method and were investigated as catalysts for the oxidation of chlorinated organic compounds. The composites retained high surface areas and pore volumes comparable with those of undoped γ-Al₂O₃ and the presence of the transition metal ions enhanced their surface acidic properties. The catalytic activity of the prepared catalysts in the oxidation of 1,2-dichloroethane (DCE) was studied in the temperature range of 250–400°C. The catalytic activity and product selectivity were strongly dependent on the presence and the type of dopant ion. While Cu^2 +- and Cr^3 +-containing catalysts showed 100% conversion at 300°C and 350°C, V^3 +-containing catalyst showed considerably lower conversion. Furthermore, while the major products of the reactions over γ-alumina were vinyl chloride (C₂H₃Cl) and hydrogen chloride (HCl) at all temperatures, Cu- and Cr-doped catalysts showed significantly stronger capability for deep oxidation to CO₂.     

Apportioning aldehydes: Quantifying industrial sources of carbonyls

<正>In their recent Journal of Environmental Sciences publication,Wang and colleagues provide field evidence that industrial activities can contribute substantially to atmospheric carbonyl concentrations(Wang et al.,2015).These results may helpto explain underestimations of carbonyl emissions in currently available emission inventories,and highlight the need for an improved understanding of industrial sources of this class of compounds.In the atmosphere,carbonyl compounds photolyze to yield     

Cu–Mn–Ce ternary mixed-oxide catalysts for catalytic combustion of toluene

Cu–Mn, Cu–Mn–Ce, and Cu–Ce mixed-oxide catalysts were prepared by a citric acid sol–gel method and then characterized by XRD, BET, H₂-TPR and XPS analyses. Their catalytic properties were investigated in the toluene combustion reaction. Results showed that the Cu–Mn–Ce ternary mixed-oxide catalyst with 1:2:4 mole ratios had the highest catalytic activity, and 99% toluene conversion was achieved at temperatures below 220°C. In the Cu–Mn–Ce catalyst, a portion of Cu and Mn species entered into the CeO₂ fluorite lattice, which led to the formation of a ceria-based solid solution. Excess Cu and Mn oxides existed on the surface of the ceria-based solid solution. The coexistence of Cu–Mn mixed oxides and the ceria-based solid solution resulted in a better synergetic interaction than the Cu–Mn and Cu–Ce catalysts, which promoted catalyst reducibility, increased oxygen mobility, and enhanced the formation of abundant active oxygen species.     

桂林市城区大气VOCs污染特征及对O3和SOA的生成潜势

对桂林市城区大气中挥发性有机物(VOCs)的污染特征,以及VOCs对臭氧(O3)和二次有机气溶胶(SOA)的生成潜势进行了研究。结果显示,研究期间,共检出VOCs物种78种,平均体积分数为21.32×10-9,表现为芳香烃(67.82%)烷烃(19.56%)卤代烃(7.50%)烯烃(2.86%)含氧挥发性有机物(1.41%)。VOCs体积分数空间分布呈现市中心和下风向郊区两个高值区。通过苯与甲苯的浓度比值发现,林科所VOCs主要来自交通源和生物源,师专甲山校区VOCs主要是来自交通源,其余测点VOCs主要来自交通源、工业源和外来传输源。分析乙苯和间/对二甲苯的浓度比值发现,电子科大尧山校区气团光化学年龄较大,光化学反应活性相对较强烈;旅游学院、华侨旅游经开区、大埠中心校气团光化学年龄较小,光化学反应活性相对较弱。VOCs对O3生成潜势最大的为芳香烃(93.81%),其次是烷烃(7.22%)和烯烃(4.75%);对SOA生成潜势最大的为芳香烃(97.45%),其次是烷烃(2.55%)。